Rally Setup Home |
 |
|
Rally Setup #1: 9" cones with holes for stakes - Industrial velcro used for attaching numbers to signs and signs to cones. The cones and velcro can be purchased at a Home Supply store. Contact me if you need more information. Using industrial velcro on my signs/numbers/cones has lasted for over 5 years. I have used my current set on a weekly classes, currently with 5 classes a week. They are still as good as new because of the 5 mil laminate I use to laminate my signs and numbers. My signs will also sit in the Wire Holders. My laminated numbers can be velcroed to the backs of my laminated signs. Having numbers above signs are helpful to exhibibors when running the courses. If you are using 9" cones, golf tees can be used to attach the cones through holes in the corners to the ground. I purchased these from www.soccerone.com. Placement of Industrial Velcro on 9" cones (below)
Rally Setup #2: 12" heavy cones - If you are using 12" cones, they are heavy enough for an ourdoor setup.
Setup #3: Wire coated easels are great for indoor courses. These can be purchased from different vendors. I purchased mine for about $17/dozen. For outdoor use, use clothespins for holding signs on easel, and also use 8 oz. of sand in a baggie for holding down easel in the back. Stakes can also be used. Small stakes can be found at any local Army Surplus store. These signs have numbers velcroed - as above. black pvc sewer pipe (not shown) - 5" diameter, 3 3/4" high. Saw a 2-3" slit into top edge (both sides) of the pipe and slide sign into slit. Picture not available.
|
On This Page My Rally Setup |
